Injection Pumps

Single Component Electric Injection Pump.

Epoxy and Resin injection pump for concrete repairing , concrete repair injection pumps

High pressure electric injection pump Product ID:  Single Component Injection Pump It is the professional machine which is applied in the structure perfusion, equipped with super pressure. To solve out the inconvenience of the carrier, it is very light and it is the best choice of stanch worker. Speedy Construction : can be advanced to 5000PSI in a few seconds, and the working time will be shorter than other machine. Low gross: It is only 7.5KG, easy to carry. Simple maintenance:can be fixed without special training, to avoid the delay for the machine fixing. Standing Pressure: can be affused into the small slot effetively, and envelop the leaking. Specifications: ① Gross: 7.5 Kg Power: 560w single-phase alternating current 220v/50Hz ② Max Output Pressure: 11000 PSI ③ Star-up: < 7500 PSI ④ Safety Scope of High-pressure pipe: < 14000 PSI ⑤ Safety Scope of On-off Valve: < 18000 PSI ⑥ Safety Scope of Butter Head: < 16000 PSI ⑦ Standard Specification: o Machine Body o 5 meters high pressure pipe o Switch Valve Suit(including Butter Head) o Metado sbe560 Eletric Drill o Maintainance Saddlebag Characteristic: 1、Environment protection: Good mechanical performance, no noise and no pollution. 2、Portable: Small, light, convenience, and easy to handle. 3、High efficiency: It can reach 0~50Mpa work pressure within several seconds, and it has advanced technique which promise a high efficiency. 4、Safety: With credible techniques and reasonable structure, you can use it safely. 5、 High pressure: With grouting pressure 0~50Mpa, it can fill in and build up tiny gap, tiny crack and hole in concrete structure. 6、No damage to structure: Install injector directly to grout, no need to lay pipes and trough. 7、In the case of streaming from aperture, comb and underground, it can grout in water, grouting material may go deep into the crack effectively. Application Scope: o For the crack, flexing crack, construction crack, and instruction crack of building and concrete project. o Leak stopping for the breast wall of artesian well in geologic drilling project. o Grouting of reservoir and dam for the water conservancy project, leak stopping of the water transporting tunnel, seepage control of the concrete crack of the embankment. o Leak stopping for underground, tunnel, culvert, sewage disposing pool, concrete fissure. o Leak stopping for basement, underground garage, and underground channels. o Leak stopping for floor, wall pipe, and wall corner. o Cracking of building, girder, pole, board etc structure, inject epoxy resin with high-handed. The electric high pressure injection pump Injection Pump is a professional machine used for fabric high pressure chemical grouting, which works with single chemical grouting material. It can produce high pressure itself. When there are leakage-stop constructions on engineering include architecture, underground, water conservancy, environment protection, civicism, subway, tunnel, culvert, crack reinforcement, it is the preferred equipment.